Netgear / Orbi Routers

  1. Reboot ONT - Equipment provided by Bridgewired
  2. Reboot Router - Equipment you connect to ONT
  3. Make sure you are connected to your routers Wifi
  4. Go to http://routerlogin.net
  5. Enter username and password
    1. Username is always admin
    2. Default password is password unless it was changed during setup
  6. From Screens below make sure settings match.
    1. Be sure to save and apply changes
  7. Check for Internet - may need to reboot devices

 

Screens May Vary based on Netgear Router type and version






TP Link Routers

  1. Reboot ONT - Equipment provided by Bridgewired
  2. Reboot Router - Equipment you connect to ONT
  3. Make sure you are connected to your routers Wifi
  4. Go to http://tplinkwifi.net
  5. Look for Advanced tab at top of page and click it
  6. Go to Network then to LAN
  7. Change IP address to 10.0.0.1 with subnet of 255.255.255.0
    1. Be sure to save and apply changes
  8. Check for Internet - may need to reboot devices

 

Screen May Vary based on TP Link Router type and version

 

 


All Routers

  1. Reboot ONT - Equipment provided by Bridgewired
  2. Reboot Router - Equipment you connect to ONT
  3. Make sure you are connected to your routers Wifi
  4. Login to your router configuration (refer to your routers documentation)
  5. Look for Local Area Network or LAN
  6. Change LAN or Local Area Network IP address to 10.0.01 with subnet of 255.255.255.0
    1. Be sure to save and apply changes
  7. Check for Internet - may need to reboot devices